User manual

3
Network Settings
3-16 Pi3505e Printer Driver
Configuring NetWare 3.2 Remote Printer Mode settings
1 Log in with Supervisor rights to the NetWare server that is registered
at the Pserver.
2 Start up Pconsole.
3 From the Available Options, select Print Queue Information, and
then click Enter.
4 Click Insert, input the Print Queue Name, and then click Enter.
5 Click Esc to return to the Available Options.
6 Select Print Server Information, and then click Enter.
7 Click Insert, input the print server name into New Queue Name, and
then click Enter.
8 Select the print server you just created, and then click Enter to display
the Print Server Information menu.
9 On the Print Server Information menu, select Print Server
Configuration. This will display the Print Server Configuration
menu.
10 Select Printer Configuration, and then click Enter. This will display
the Configured Printers list.
11 Select Not Installed at the top of the list, and then click Enter. This will
display the Printer 0 Configuration screen.
12 In the Name field, change the printer name to Pi3505e, and then click
Enter.
13 Select Type, and then click Enter. Select Remote Parallel, LPT1 and
then click Enter to register the print server configuration.
14 Click Esc to save your settings.
15 Click Esc again to return to the Print Server Configuration menu.
16 Select Queues Serviced by Printer and then click Enter.
17 On the Defined Printers list, select the Pi3505e printer you configured
in step 12 above, and then click Enter.