User manual

3
Network Settings
3-14 Pi3505e Printer Driver
9 On the Print Server Information menu, select Print Server
Configuration. This will display the Print Server Configuration
menu.
10 Select Printer Configuration, and then click Enter. This will display
the Configured Printers list.
11 Select Not Installed at the top of the list, and then click Enter. This will
display the Printer 0 Configuration screen.
12 In the Name field, change the printer name to Pi3505e, and then click
Enter.
13 Select Type, and then click Enter. Select Remote Parallel, LPT1 and
then click Enter to register the print server configuration.
14 Click Esc to save your settings.
15 Click Esc again to return to the Print Server Configuration menu.
16 Select Queues Serviced by Printer and then click Enter.
17 On the Defined Printers list, select the Pi3505e printer you configured
in step 12 above, and then click Enter.
18 Click Insert to display the Available Queues list for the printer.
19 Select the queue you created in step 4, specify a priority value in the
range of 1 (highest) to 10 (lowest), and then click Enter.
20 Click Esc to quit Pconsole.
❍ For information about configuring settings for queue user
privileges, printer alert options, multiple queues, and passwords,
see NetWare documentation.
21 Start up PageScope Light and log in to the Admin mode. On the
Network tab, select Common Settings and then NetWare. Configure
the settings described below. For more information, see “Using
PageScope Light” on page 3-26.
22 Load MONITOR.NLM onto the NetWare Server console.