User manual

Network Settings
3
Pi3505e Printer Driver 3-7
11 If the test prints normally, complete the procedure by clicking OK to
close the Properties dialog box.
After you finish installing a printer with the above procedure, you can use
it just as you would any standard local printer. The printer can also be
used as a network printer by other Windows computers on your network
whose Windows NT 4.0 systems are configured the same way as
described above.
Configuration Procedure (Windows 2000/XP)
1 Install TCP/IP under Windows 2000/XP.
❍ Refer to the applicable Windows documentation for more
information.
2 Assign the IP parameters.
❍ See “Specifying the IP Address From the Copier’s Touch Panel” on
page 3-2 for more information.
3 Use the procedure below to install the printer.
Installing the printer (Windows 2000/XP)
1 Install the printer driver following the instructions that come with the
installer. Make the new printer the default printer.
2 Right-click the new printer icon and select Properties from the menu.
3 Display the Ports tab.
4 Click Add Port.
This displays a list of available port types.
5 Select Standard TCP/IP Port from the list, and then click New Port.
This starts Add Standard TCP/IP Printer Port Wizard.
6 Click Next on the introduction page of the wizard.
7 On the Add Port page, type the IP address of the Network Card into
the Printer Name or IP Address box.
❍ If the network you are on uses DNS (Domain Name Services), type
in the DNS name instead of the IP address.