User`s guide

6
Working with the printer
6-6
4
Squeeze the right media guide and adjust the media guides so that
both the left and right sides of the media are secure.
Loading media in the manual feed tray
1
Open the media guides.
2
Insert the piece of media as far as
possible into the manual feed tray
(with the side to be printed facing
up).
?
How many pieces of media can
be fed at one time?
➜ Insert only one sheet of paper or
type of media at a time.
?
How are envelopes fed in?
➜ Place the envelope in the tray with the side to be printed facing up.
The flap of the envelope should be facing down and to the left.
?
How is letterhead fed in?
➜ Load letterhead with the side to be printed facing up and the pre-
printed letterhead at the top (facing the printer).
Loading media in the lower feeder unit (Tray 2)
Note the following points:
✔ The optional lower feeder unit (Tray 2) is shipped with either a letter or
A4 tray. Legal and executive/B5 JIS trays are also available as option-
al accessories.
✔ Refill the tray only when it is completely empty.
✔ Paper must be loaded short edge first.
✔ Refer to the advice on loading media on page 6-1.
1
Remove Tray 2 from the lower feed
unit by pulling it out as far as it will
go, gently raising up the front, and
sliding it the rest of the way out.