User`s guide

Installing and setting up the printer
2
2-13
USB interface
✎
Note
Windows 95/NT4.0 do not support USB connections.
1
Turn off both the PC and the printer.
2
Turn on the PC.
3
Turn on the printer.
4
When Windows and the printer are both ready, connect one end of the
interface cable to the PC’s USB port .
5
Connect the other end of the
interface cable to the USB interface
connector on the back of the printer.
?
Does the Windows operating
system detect the new device?
➜ Plug-and-play driver installation
should start automatically. Fol-
low the instructions on the
screen. See chapter 3 for more
information.
➜ If plug-and-play driver installation doesn’t start automatically, leave
the printer on, unplug both ends of the interface cable, and the re-
connect the cable. If this does not work, use the instructions in
chapter 3 to install the printer driver manually.
For technical specifications of the cable, see chapter 10.
✎
Note
Using the wrong type of cable can damage the socket on the
printer.
- Use only a USB Revision 1.1 compliant cable for connecting the
printer to your computer.