Instruction manual

CUSTOM FUNCTIONS

1 – AF priority

Shutter will not release until or appears in the viewfinder.

Cust 1 – AF Release Priority

Cust 2 – Film Rewind Start

2 – Release Priority

Shutter releases even if the focus cannot be confirmed. Use Release

priority when photographing moving subjects.

• When continuous-advance mode is selected, the camera will not update the

focus while the shutter-release button is pressed.

1 – Automatic

Film is automatically rewound at the end of the roll.

2 – Manual

Press the manual-rewind button to initiate

rewind. (p28).

Cust 3 – Film Tip

1 – Film is completely rewound into the cartridge.

2 – Leader is left out of the

cartridge after rewind.

• Sliding the main switch to LOCK

during rewind causes the film to be

rewound into the cartridge when the

power is switched back on.

1 – DX Memory Off

Film speed is always set to the DX-coded ISO. Non-DX-coded film is

set to the ISO of the previous roll.

Cust 4 – DX Memory

2 – DX Memory On

Changes to the film speed for a DX coded roll are saved and applied

to future rolls with the same DX coded ISO. Use to consistently

over/under-expose a specific film type.

• Film must be loaded before the ISO can be changed.

1 – Autoswitchover

Built-in flash pops-up when shutter-release button is pressed partway

down. Flash will fire when necessary.

Cust 5 – Flash Control in P Mode

2 – Fill Flash (Manual Switchover)

Flash-mode button must be pressed to

raise the built-in flash (p26). Flash will fire

every time the shutter is released.

• The TTL exposure system will ensure

correct exposure.

• Push the built-in flash down to select

flash cancel ( ).