User manual

Slider speed:
maximum 200mm/s - in VIDEO program
minimum 100mm/99h - in TIMELAPSE program
Operating temperature
range:
-10°C do 70°C
Shutter release cable
(one to choose):
WS-1, WS-2, WS-3, WS-4, WS-5, WS-6, WS-7
cables used in ANIMATION, TIMELAPSE programs
Payload:
10kg
5. Mounting Slide Kamera HKN-2 stepper drive
If you purchased HSO-4 rotational slider in a set with HKN-2 stepper drive you will receive a slider with the drive
already mounted. However, if you intend to purchase HKN-2 stepper drive for your HSO-4 slider, it is necessary
to send your equipment back to Slide Kamera manufacturer in order to have the drive mounted properly.
6. How to operate the controller
After you switch the power on the startup screen will appear on LCD for about 1,5s. with the information
about HKN-2 stepper drive software version: rev 2.0.
6.1. Specifying startup parameters
After switching the power on it is necessary to determine startup parameters for our drive, namely points
of reference. This kind of calibration is necessary every time we switch the drive on. Please note that HSO-4
rotational slider comes with no limit switches (only HSK series sliders come with limit switches), therefore
we differentiate only two types of calibration:
 NO LIMIT SWITCHES: manual calibration (MANUAL Calib.)
 NO LIMIT SWITCHES: no calibration (FREE Mode)
IMPORTANT !!!
Only Slide Kamera manufacturer can mount HKN-2 stepper drive to HSO-4 rotational slider.
Any attempts to mount the drive can cause serious damage to the equipment the manufacturer
is not responsible for. If you fail to comply with the abovementioned condition, the manufacturer
reserves the right to refuse the complaint.
7
Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider