User manual

„V”: means that the battery voltage is too low. Replace the battery immediately in order to avoid to a sudden
stop of the drive, which may result in damage to the equipment.
„t”: (Thermal Warning) indicates temperature warning. Turn off the drive immediately so as not to overheat
the driving motor.
„T”: (Thermal Shutdown) indicates emergency drive shutdown due to overheating. You should immediately turn
off the drive and wait until FAULT light switches off.
6.2.2. VIDEO
As you enter VIDEO program a submenu will appear on the screen with different operating modes:
[Free Ride], [Recording], [Playback], [VideoLoop] ,<Back>.
6.2.2.1. Free Ride
Free Ride mode allows the user to control the speed of the slider using joystick and adjusting knobs. SPEED knob
sets the maximum speed desired by the user. DAMPING knob is used to determine the time at which
the drive reaches the desired speed or stops, what allows to achieve very smooth acceleration and deceleration
of the slider. By moving the joystick right or left you can control the level of acceleration / deceleration of the slider.
Pressing the joystick causes the driving motor to stop immediately and the centroller returns to VIDEO menu.
When you work in Free Ride mode you can change SPEED and DAMPING parameters at any time during
the movement. SPEED knob allows to set the speed value within the range of 2 -200mm/s. DAMPING knob allows
to set the acceleration/deceleration time within the range from 0.1s to 10s. Sample screen presented above
informs that the maximum speed of the slider is set on 200mm /s [2], currently set speed of the slider
is 169mm/s [3].The value 1.2 [4] , means that the maximum speed will be achieved after 1.2 seconds.
Please note that depending on the chosen method of calibration the current position of the cart is measured
and presented on the screen in a different way. Table on the next page illustrates and explains the messages
on the controller. Table refers to all modes and programs unless it is indicated otherwise in the manual.
VIDEO
TIMELAPSE
FreeRide 1100.1
200 169 1.2
Current position of the slider, measured in mm [1]
Maximum speed of the slider set by the user [2]
Currently set speed [3]
Acceleration / deceleration time [4]
1
2
3
4
10
Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider