User manual

6.2. Main menu

As soon as you determine/set the reference points for the drive you can enter a main menu with working programs

and additional menu CONFIG. Navigate by moving joystick up and down. Sign " " indicates selected

choice. Press the joystick to ented selected program. Main menu has four entries: „VIDEO”,

„ANIMATION”, „TIMELAPSE” and „CONFIG”.

6.2.1. Menu CONFIG

After entering [Info] there will be information about the voltage: Vin, and range of motion for the cart

determined during automatic calibration: L. The latter can be determined only when working with Slide Kamera

HSK series sliders. In case of HSO-4 rotational slider, there is no automatic calibration of the driving motor

so the parameter will always be: L ----.

Power- driving motor power: 33/66/100%. By moving the joystick left or right you can set the power value.

Setting a lower power can significantly increase the working time on battery supply.

Back Light adjusts the brightness of the LCD. By moving the joystick left or right you can set the brightness -

within the range of: 10-100%

[Calibration] - driving motor automatic calibration; does not apply to HSO-4 rotational slider.

<Back> - return to main menu

ANIMATION

CONFIG

CONFIG menu has five entries "[Info]",

"Power", "Backlight","[Calibration]"

and "<Back>". The list boxes in square brackets []

indicate functions generating own screen. In order to activate

them, press the joystick. At the end of each submenu there

is "<Back>". Pressing the joystick in this field results in returning to the main menu. The remaining fields

of the submenu are the parameters, next is the value of the parameter. To change the value move the joystick right

or left.

Vin=9.8V V

L ----

WARNING!

If the backlight of the LCD screen starts flashing and there wil be an orange

flashing light under FAULT marking on the right socket of the driving motor,

the user is informed about existing error. In such situation, immediately enter

CONFIG menu → [Info]. Information about the error should appear

in the upper right corner of the screen.

Exercise extreme caution when working with the drive in FREE Mode. Lack of reference points

increases the risk of the slider hitting any possible obstacle.

It may cause a serious damage to the equipment.

Slide Kamera HKN-2 stepper drive for HSO-4 rotational slider