User Guide
Table Of Contents
- QMS magicolor 2 Print System Operation
- Contents
- Introduction
- Consumables
- Advanced Printing Features
- Color Printing
- Printer Care
- CrownView Printer Web Page
- Media Jams
- Troubleshooting Printer Problems
- Introduction
- Status and Service Messages
- HP-GL Error Codes and PCL Error Codes
- Testing PC-Printer Communication
- Testing Macintosh-Printer Communication
- Printer Problem Checklist
- OPC Belt Cartridge Problems
- Control Panel Problems
- Windows Driver Problems
- CrownNet Problems
- Output Problems
- Kanji Option Kit Problems
- Print Quality Problems
- Color Density Problems
- Image Defects
- Placing a Service Call
- Repacking the Printer
- QMS Customer Support
- Configuration Menu
- Index
Color Density
QMS magicolor 2 Op
eration4-10
4 Compare the calibration page to
the four calibration cards that
were provided with your printer.
Each card features a single color—
cyan, magenta, yellow, or black.
a Place the calibration page on a sheet of clean white paper in
a well-lighted area.
b Align the cutout in the cyan color
calibration card over the cyan
column on the calibration page.
c Decide which block on the calibration page most closely
matches the cyan color calibration card.
» Note:
It may be easier to decide which colors match if you
view the output at a distance (3–4 feet) and squint.
d Make a note of the value (-4 to +4) associated with that block,
or simply mark the pane through the cutout in the card.
You will need this value in step 6.
e Repeat steps b–d with the magenta, yellow, and black
calibration cards.
5 Access the printer’s Administration/Engine/Density/Cyan
menu.