User Guide
Table Of Contents
- QMS magicolor 2 Print System Operation
- Contents
- Introduction
- Consumables
- Advanced Printing Features
- Color Printing
- Printer Care
- CrownView Printer Web Page
- Media Jams
- Troubleshooting Printer Problems
- Introduction
- Status and Service Messages
- HP-GL Error Codes and PCL Error Codes
- Testing PC-Printer Communication
- Testing Macintosh-Printer Communication
- Printer Problem Checklist
- OPC Belt Cartridge Problems
- Control Panel Problems
- Windows Driver Problems
- CrownNet Problems
- Output Problems
- Kanji Option Kit Problems
- Print Quality Problems
- Color Density Problems
- Image Defects
- Placing a Service Call
- Repacking the Printer
- QMS Customer Support
- Configuration Menu
- Index
Testing
Macintosh-Printer
Communication
QMS magicolor 2 Op
eration8-18
Verifying the Serial Setting Changes
1 Turn the printer off and on again to produce a start-up page.
2 Compare the serial port settings listed on the start-up page
to those in your AUTOEXEC.BAT file.
3 Try the communication test again.
If a blank page ejects from the printer, the printer and the PC are
communicating. If a blank page doesn’t eject and you typed the file
correctly, refer to your DOS documentation for more information.
Testing Macintosh-Printer
Communication
Testing Macintosh Communication
You can check communication between the printer selected in the
Chooser and the Macintosh by sending a file to the printer from an
application (see your application documentation for more information)
or by printing a directory, as described here:
1 Display a disk or folder window.
Online/
Offline
Access the Save Changes option. SAVE CHANGES?
*NO
Next Advance to the Yes option. SAVE CHANGES?
YES
Select Save changes. IDLE
Online/
Offline
Put the printer back on line (the
Ready indicator lights).
IDLE
Press this
key...
to... The message window
reads...