Instruction manual

E31
Basic OperationBasic Operation
E30
★ When measuring flash light using a sync cord (CORD mode), the flash
may fail to fire (e.g. if the trigger voltage of the flash is too low). In this
case, take a reading without sync firing the flash (NON CORD mode).
If the f-number reading exceeds or
falls below the meter’s measuring
range, the display shows “E.o.”
(over-range error) or “E.u.”
(under-range error).
If the f-number reading is outside
the meter’s display range, “FNo.”
blinks and the display shows either
“
– O – ” (over-range error) or “ – U – ”
(under-range error). At the same
time, the over-range/under-range
error indicator (▲ or ▼) appears
on the analog scale.
flashmeter_vi_eng.qx33 02.12.25 9:21 PM ページ 30