Instruction manual

PreparationsPreparations
12 13
4) TIME/CINE setting
Switches between shutter speed and frame rate in AMBI mode
Note that it is not possible to switch to another measuring mode
(CORD or NON CORD) while the frame rate setting is active.
display
display
1
Turn the power on while
pressing the ISO button,
or press the ISO button in
Alt mode.
♦ Alt (bottom left) and TIME step
value (center left) are displayed.
2
Use the up/down key to
set the step value.
♦ Choose from values of 1.0, 0.5
and 0.3.
1
Turn the power on while
pressing the mode button,
or press the mode button
while in Alt mode.
♦ Alt (bottom left) and TIME value
or CINE f/s (center left) are
displayed.
2
Use the up/down key to
set the shutter-speed or
frame rate value you
desire.
♦ Choose mode from TIME and
CINE.
Displays FNo. with one digit after
the decimal point to indicate 1/10
stops.
1
Turn the power on while
pressing the display-
selector button, or press
the display-selector button
in Alt mode.
♦ Alt (bottom left) and an FNo.
value of 0 (center right) are
displayed.
For quickly reading values
between f-numbers (e.g F3.5,
F4.5)
2
Use the up/down key to
select FNo. display.
♦ Choose your preferred display
method from the two options
above.
3) FNo. display
Specifies FNo. display
2) Shutter speed increments
Choose between increments of 1/2-stop, 1/3-stop and 1-stop,
according to the shutter speed settings your camera.
AutoMeter_VF.qxd 02.7.8 1:31 PM ページ 12