Instruction manual

6 7
Names of Parts and DisplaysNames of Parts and Displays
9. Measuring mode indicators
Press the mode button repeatedly to select and display one of the three
measuring modes: AMBI, CORD or NON CORD. The measuring mode
changes in the following order each time the mode button is pressed:
AMBI ➞ CORD ➞ NON CORD ➞ AMBI ...
10.Reflected-light indicator
This indicator lights up when you use a reflected-light attachmentⅡ or
Viewfinder 5°.
11.Quadrant proportion indicator
This indicates the approximate proportion of flash light in the total
exposure when measuring flash light.
12.Flash light measuring indicator
This indicator lights up during measurement in CORD mode and NON
CORD mode.
13.Brightness difference function indicator
This indicator lights up when you press the S/A/H button. For details of
the brightness difference function, see page 49.
8
13
7
11
10
9
12
7. Memory indicator
When you press the memory button to store a reading in memory, one
of these dots lights up. If one reading is stored in memory, one dot is
displayed; if two readings are in memory, two dots are displayed.
8. S/A/H indicators
: This lights up when you press the S/A/H button.
/
:S or H can be selected by using the up/down key while holding
down the S/A/H button during reflected-light readings.
Select to measure the exposure of shadow areas; select to
measure highlight areas.
AutoMeter_VF.qxd 02.7.8 1:31 PM ページ 6