Instruction manual

Accessories
62 63
Care and Storage
1. Care
1) If the meter gets dirty, it can be wiped with a soft, dry cloth. Do not use
solvents such as thinners or benzene at all.
2) If the Spherical Diffuser becomes stained, remove it from the meter,
wash the diffuser carefully in water with a mild detergent, and rinse and
dry the diffuser thoroughly before reattaching it to the meter.
3) Never attempt to disassemble the meter if it becomes damaged or
faulty. Consult the contact given in the attached sheet, “After Service
Information.”
2. Storage
1) The meter should not be stored in areas where it may be subject to
temperatures higher than 55°C (131°F) or lower than -20°C (-4°C), or in
areas subject to high humidity. It is recommended that the meter be
stored in an airtight container together with a drying agent such as
silica gel.
2) Do not leave the meter in places such as the rear window or trunk of a
car, otherwise it will get extremely hot, resulting in damage. Remove
the battery whenever the meter is left unused for more than 2 weeks, to
avoid the risk of damage due to battery leakage.
Sync Cord III
This is a 5-meter long cord that
connects together the Auto Meter
VF, flash unit and camera's sync
terminal. Using this cord, you can
take flash exposure readings by
simply releasing the shutter,
without changing any connections.
Common accessories
Item Possible/impossible Condition
Viewfinder10°II Possible Set exposure correction to +3.0Ev.
Reflected-light attachment Possible Set exposure correction to +3.0Ev
Booster II Possible Nothing particular
ND receptor Possible Nothing particular
AutoMeter_VF.qxd 02.7.8 1:31 PM ページ 62