Instruction manual

Basic Operation
3130
Basic Operation
3
Attach the flash sync cord
to the meter's sync
terminal.
★ Take care when connecting
the flash to the meter, as the
flash may fire.
4
Use the up/down key to
select the shutter speed of
your camera.
● Shutter speeds can be set
within the range of 1 sec. to
1/500 sec. (The speed can be
set within the flash sync speed
range of your camera.)
● Each time you press , the
shutter speed increases.
Holding down increases the
value continuously. The value
cannot be increased above
1/500 sec. even if you continue
pressing.
● Each time you press , the
shutter speed decreases.
Holding down decreases
the value continuously. The
value cannot be decreased
below 1 sec. even if you
continue pressing.
Battery (p. 8)
↓
Shutter speed increments (p. 12)
↓
FNo. display (p. 12)
↓
Film speed (p. 14)
↓
Incident-light reading and
reflected-light reading (p. 15)
1
Prepare the meter to start
taking readings.
1. With a sync cord
Measuring flash light
2
Press the mode button to
switch the mode display to
CORD.
● When the measuring mode is
changed, previous readings and
values in memory are deleted.
● Settings for shutter speed and
display units are automatically
adjusted as follows.
1/640 to 1/8000 sec.:
adjusted to 1/500 sec.
1.3 sec. to 30 min.:
adjusted to 1 sec.
EV: adjusted to FNo.
AutoMeter_VF.qxd 02.7.8 1:31 PM ページ 30