Specifications

•

When the copier determines that toner replenishing is to be carried out

based on the ATDC output voltages, M15 is controlled by the signal

output from pin 70 of IC4A on PWB-A.

•

For the timing at which M15 is energized (toner replenishing timing) and

the period of time during which M15 is kept energized (toner

replenishing time), see 13-5. ATDC Sensor.

1075C07MAA

PC Drum Drive Motor M5 is energized.

Toner supplied from the Main Hopper is conveyed by the Sub Hopper

Toner Conveying Screw and fed at the center of the screw to the Sub

Hopper (Sub Hopper Toner Agitating Lever).

The Sub Hopper Toner Agitating Lever evens out the toner towards the

front and rear, while agitating it. Toner is then fed under the Toner

Regulator onto the Sub Hopper Toner Replenishing Roller.

Sub Hopper Toner Replenishing Motor M15 is energized.

The Sub Hopper Toner Replenishing Roller is turned by a gear train to

feed toner into the Developer Mixing Chamber.

M-81