Specifications

8-3. Grounding of the PC Drum
The PC Drum ground point is inside the rear end. When the PC Unit is slid
into the copier, the Drum Holding Shaft contacts the ground point. This
provides for assured grounding of the PC Drum through the Ground Plate in
the rear to the frame of the copier.
Conductive
Grease
Ground
Plate
Drive Gear
Coupling Gear
Ground Point
Drum Holding
Shaft
8-4. Drum Dry Heater
•
Drum Dry Heater H4 is located beside the Image Transfer/Paper Separator
Coronas. It is a panel heater that prevents condensation from forming on
the surface of the PC Drum.
•
H4 turns ON when:
1. The power cord is plugged in the wall outlet.
2. Power Switch S1 is in the OFF position.
3. Drum Dehumidifying Switch S9 is in the ON position.
Image Transfer/Paper
Separator Coronas
M2
H4
S9
1075C02MAA
M-27