Specifications

<Fusing/Exit Misfeed Clearing Procedure>
Symptom Step Check Item Result Action
•
Paper is at a
stop before
the Fusing
Roller.
1
Is the Fusing Guide Plate dirty or
deformed?
YES
Clean or change the
Fusing Guide Plate.
2
Refer to Section 3-2
"Transport/Separator Misfeed" and
check the Suction Fan Motor M18.
 
•
Paper is at a
stop in the
Fusing Roller
Section.
1
Are the Fusing Rollers dirty or
scratched?
YES
Clean or change the
Fusing Rollers.
2
Are the Fusing Roller Paper
Separator Fingers dirty, worn or
deformed?
YES
Clean or change the
Paper Separator Fingers.
3
Is the Oil Roller dirty?
YES
Clean or change the Oil
Roller.
•
Paper is at a
stop in the
Paper Exit
Section.
1
Check the Paper Exit Sensor PC36.
 
1)
2)
Remove the misfed paper.
Select "IC Port Data Check".
3) Is the data of APB3 on PWB-A
(IC5A) " "?
(See the 2/8 screen on T-7.)
NO
Check the operation of
the Actuator.
4) Operate the Actuator to block
PC36.
 
5) Return to the "I/O Check" menu
screen and select "IC Port Data
Check" again. Has the data of
APB3 changed from " " to
" "?
YES Change PWB-A.
NO
Change PC36.
H
H
L
T-27