Specifications

Symptom Step Check Item Result Action
•
Paper is at a
stop in the
Vertical
Transport
Section.
1
Are the Vertical Transport Rollers
deformed, worn, or dirty with paper
dust?
YES
Clean or change the
Vertical Transport
Rollers.
2
Is the Paper Take-Up or Vertical
Transport Guide Plate deformed or
dirty?
YES
Clean, correct, or
change.
3
Does Vertical Transport Motor M2
rotate when the Start Key is turned
ON?
YES Check for overload.
NO
Change PWB-F, PWB-A
or M2.
4
 When the 1st Drawer is used 
Check 1st Drawer Paper Take-Up
Sensor PC6
 
1)
2)
Remove the misfed paper.
Select "IC Port Data Check".
3) Is the data of PA2 on PWB-F
(IC2F) " ". (See the 5/8 or 6/8
screen on T-7.)
NO
Check the operation of
the Actuator.
4) Operate the Actuator to block
PC6.
 
5) Return to the "I/O Check" menu
screen and select "IC Port Data
Check" again. Has the data of
PA2 changed from " " to " "?
NO
Change PC6.
5
Check the Vertical Transport
Sensor 1 PC10.
 
1)
2)
Remove the misfed paper.
Select "IC Port Data Check".
3) Is the data of PA1 on PWB-F
(IC2F) " ". (See the 5/8 or 6/8
screen on T-7.)
NO
Check the operation of
the Actuator.
4) Operate the Actuator to block
PC10.
 
5) Return to the "I/O Check" menu
screen and select "IC Port Data
Check" again. Has the data of
PA1 changed from " " to " "?
YES
Change PWB-F or
PWB-A.
NO
Change PC10.
L
L
H
H
H
H
T-16