Specifications

6
ADJUST MODE
•
This mode is used to adjust the optical components before shipment from the factory and must not
be executed except when the PWB-R (RAM Board) has been changed. When the PWB-R has
been changed, enter the factory settings indicated on the Label inside the Front Door.
6-1. Adjust Mode Screens
1075S006CB
Adjust
Enter
Adjust 1/2
Next
A0 Lens Focus
A1 Lens Full Size Position
A3 Feed Direction Mag. Ratio
A4 Lens Position Full Size
A5 Lens Position Reduction
50
50
50
50
50
49-51
6-2. Adjust Mode Setting Procedure
<Setting Procedure>
1. Place the copier in the Tech. Rep. mode by pressing the following Keys.
Stop Key → "0" → Stop Key "1"
2. Then, place the copier in the Adjust Mode with the following Keys.
Stop Key → Start Key
3. Make various settings according to the screen selected.
4. Using the ▼/▲ key, select the function of the Adjust Mode to be set.
Note: Press the "Next" or "Back Up" key to switch the screen from one to the other.
5. Using the / key, select the setting.
6. Press "Enter" to enter the setting.
Note: In regard to A0, A1and A10, after pressing Enter Key, setting is completed by turning the
Power switch OFF and ON.
<Leving the Mode>
•
Press the Panel Reset Key.
▼ ▲
1075S007CA
Adjust
Enter
Adjust 2/2
BackUp
A6 Book B-Scan Regist
A10 Lens Position Adjust
A11 Lens Position Enlargement
A12 Leading Edge Erase Adjust
A13 Trailing Edge Erase Adjust
50
50
50
50
45-55
S-63