Specifications

4. Press the "Next" key.
5. Select "Dial Mode" and set the Dial Mode with the "Change" key according to the type of the
telephone line used.
Pulse line P10/P20
Tone line Tone
6. Select "Auto Receive" and specify "Yes" or "No" using the"Change" key.
Yes There is a DT-103 dedicated line.
No There is no DT-103 dedicated line.
Note: When there is no DT-103 dedicated line, specify "No".
7. Select "RAM Clear" and select "No" using the "Change" key.
Yes To make setting again.
No Normal setting
Note: Select "Yes" to change CT-ID or DT-ID after completion of the set-up. If "Yes" is not selected,
the setting cannot be changed.
● Data Save
Used to transmit the User’s Choice/Tech. Rep. Choice settings to the Center.
● Data Load
Used to return the Choice settings transmitted to the Center by Data Save.
● Initial Transmission
Used when the DT-103 has been set up to give a transmission command from the Data Terminal
to the Center to check the communication status.
Any of the following messages is displayed according to the communication status:
Message Displayed
End of normal data trans. Connection failed.
Line is busy. DT modem error.
Not answering. Connected.
Max. trial number reached.
● Call Completion
Notifies the Center that the maintenance of the machine is complete.
S-54