Specifications

● Paper Path Sensors Check

The passage of paper causes the states of the Paper Path Sensors to be switched from "1 to 0"

or "0 to 1" in order of paper passage. This allows checking whether the Sensors are "normal" or

"faulty".

Screen Display Sensor Name

1 1st Feed 1st Drawer Paper Take-Up Sensor (PC6)

2 2nd Feed 2nd Drawer Paper Take-Up Sensor (PC7)

3 3rd Feed 3rd Drawer Paper Take-Up Sensor (PC8)

4 4th Feed Not Use

5 1st Vertical Vertical Transport Sensor 1 (PC10)

6 2nd Vertical Vertical Transport Sensor 2 (PC11)

7 3rd Vertical Vertical Transport Sensor 3 (PC12)

8 4th Vertical Not Use

9 Trans. Roller Transport Roller Sensor (PC26)

10 Leading Edge Paper Leading Edge Sensor (PC27)

11 Exit Section Paper Exit Switch (PC36)

12 Turnover Duplex Unit Turnover Path Sensor (PC39)

13 Dup Entrance Duplex Unit Paper Entry Sensor (PC38)

14 Dup Exit Duplex Unit Paper Take-Up Sensor (PC40)

Note: "0": Paper present, "1": Paper absent

•

Select the paper path (Drawer/Duplex Unit) to be checked, enter this mode, and press the Start

Key.

Note: When "Auto Paper" has been selected, paper is not passed (the check is not made).

S-49