Specifications

● Copy Kit Counter
Used to select "Yes" or "No" for "Copy Kit" counting by the Consumables Counter or to "Enable"
or "Disable" a copy cycle when the Counter reaches the set count.
Screen Display Description Initial Setting
No No count
∗
Mode 1
Copy enabled when the Counter reaches
the set count.
Mode 2
Copy disabled when the Counter reaches
the set count.
Note: Select Mode 1 or 2 to start the Copy Kit Counter counting. If "No" has been set for
Maintenance Call, the Maintenance Call message is displayed together with the inspection
code "M4" when the Counter reaches the set count.
● Toner Empty Stop
Used to select "Disable Copy" or "Enable Copy" after a Toner Empty condition is detected.
Screen Display Initial Setting
Enable Copy
Disable Copy
∗
Note: When "Disable Copy" has been selected, the copy cycle is inhibited on detection of a 2% or
less toner-to-carrier ratio.
● Auto Paper Config.
Used to automatically select "Metric or Inch" paper or "Metric" paper for the original size detected .
Screen Display Description Initial Setting
Metric/Inch
The copier automatically selects metric or
inch paper for the original detected.
∗
Metric
The copier automatically selects metric
paper for all originals detected.
S-30