Specifications

4
USER’S CHOICE MODE
•
This mode is used by the user to make various settings according to user requirements.
4-1. User’s Choice Mode Menu Screen
•
Select the User Mode key on the control panel.
1134P359CA
User Mode
Exit
Toner Re-
Plenisher
Job Memory
Input
Data Send
Drum De-
humidifier
Zoom Mem-
ory Input
User's
Choice
Meter
Count
Select a function by pressing the
key.
•
From among the modes displayed, select User’s Choice to enter the User’s Choice mode.
•
The User’s Choice mode has a total of six screens. Press any of 1/6, 2/6, 3/6, 4/6, 5/6 and 6/6 to
switch to the required menu screen as described below.
Note: "The selection Data Send" is displayed only when the copier is fitted with the DT-103.
4-2. User’s Choice Mode Setting Procedure
<Setting Procedure>
1. Press the User Mode key on the control panel.
2. Select the desired menu screen from among 1/6, 2/6, 3/6, 4/6, 5/6 and 6/6 displayed at the
bottom of the screen.
3. On the menu screen selected, select the mode to be set and make settings as required.
4. After the settings are complete, press the "Enter" key to enter the settings.
Note: The mode selected is highlighted.
<Leving the Mode>
Perform any one of the following steps.
•
Press the Panel Reset Key.
•
Press "Exit" on the screen.
S-11