Specifications

4. Remove one screw and the Image Transfer/Paper
Separator Coronas.
1. Blow all foreign matter off the Grid Mesh with a blower
brush.
1. Open the Front Lower Door.
2. Remove the Image Transfer Cover.
3. Unplug the connector of the Pre-Image Transfer Guide
Plate and that of the Image Transfer/Paper Separator
Charge Wire Cleaning Motor.
(4) Removal of the Image Transfer/Paper Separator Coronas
(3) Cleaning and Replacement of the Grid Mesh
If the blower brush is not effective in cleaning the
Grid Mesh, use a soft cloth dampened with alcohol to
clean serious contamination.
NOTE
Place the Grid Mesh on a flat surface and sweep the
cloth along the mesh.
Do not touch the cleaned Grid Mesh with bare hands.
NOTE
1075D107AB
2. When installing the Grid Mesh, make sure that it does
not ride on the protrusions indicated by the arrows.
D-48