Specifications

3. Holding onto both ends of the PC Drum, turn the PC

Drum 1/2 turn in the direction of arrow A, then turn it

one turn in the direction of arrow B.

1. Remove the Rear Lower Cover.

2. Remove one screw and the Ozone Filter Cover.

3. Pull out the Ozone Filter and replace it.

1075D100AA

1. Open the Front Lower Door and release and swing up

the Upper Half of the copier.

2. Remove one screw and the PC Ground Plate. Replace

the PC Ground Plate.

1075D102AA

1. Remove the Rear Lower Cover.

2. Remove the Toner Collecting Bottle and replace it.

1075U063CA

Function

F1 Paper Passage

F2 Drum/Trans

F3 Exp. Lamp

F4 HV Separator

F5 Optimum & AE

F6 Edit Ref. Adj

F7 Orig. Sensor

F8 ATDC Adjust

FD Paper Width

FE Blade Priming

4. Reinstall the PC Unit and run the FE operation (Blade

Priming) of "Function" available from the Tech. Rep.

mode.

(13) Replacement of the PC Ground Plate

(15) Replacement of the Toner Collecting Bottle

(14) Replacement of the Ozone Filter

When the Toner Collecting Bottle has been replaced,

clear the "Toner Collect" count of "Consumable"

available from "Counter" under the Tech. Rep. mode.

NOTE

D-46