Specifications

1075D095AA
1. Remove the PC Drum Paper Separator Fingers Assy.
2. Remove two screws shown.
3. Unplug one connector and remove the Toner Antispill
Seal and Pre-Cleaning Erase Lamp.
1075D096AA
1. Remove the PC Drum and Main Erase Lamp.
2. Remove two screws and the Cleaning Blade and
replace it.
1075D097AA
1. Before installing the PC Drum, apply lubricant
(shipped with the new Cleaning Blade) to the cleaning
felt pads at both ends of the PC Drum. Also apply
toner to the entire surface of the Cleaning Blade.
When installing the Cleaning Blade, press it against
the mounting bracket.
NOTE
1075U047AA
2. Install the PC Drum and apply a thin coat of toner to
the surface of the PC Drum.
(11) Removal of the Toner Antispill Seal and Pre-Cleaning Erase Lamp
(12) Replacement of the Cleaning Blade
When the Cleaning Blade has been replaced, perform the following steps.
D-45