Specifications

7. Assemble the Scanner Drive Shaft Assy and install it
in the copier.
8. Loop the side of the cable with one fixing bead around
the outer pulley for the 2nd/3rd Mirrors Carriage and
hook the fixing bead to the adjustable anchor.
∗
The illustration shows the front side of the copier. The
same applies to the rear side.
9. Loop the side of the cable with two fixing beads
around the pulley on the frame and the inner pulley for
the 2nd/3rd Mirrors Carriage and hook the fixing bead
to the spring anchor.
∗
The illustration shows the front side of the copier. The
same applies to the rear side.
6. Wind the shorter length of the cable counterclockwise
two turns, working from the front to the back side.
Then, slip the Cable Holding Jig onto the pulley.
When securing the Scanner Drive Shaft Assy, press it
against the optical frame.
NOTE
10. Remove the Cable Holding Jigs.
11. Mount the Scanner Motor and timing belt and make the Scanner Motor timing belt adjustment.
(For details, see "ADJUSTMENT.")
12. Mount the Scanner and perform the "Focus-Positioning of the Scanner and 2nd/3rd Mirrors
Carriage." (For details, see "ADJUSTMENT.")
Make sure that no part of the cable rides on the other.
NOTE
D-40