Specifications

2. Holding the pulley as shown, wind the side of the

cable with two fixing beads clockwise six turns around

the pulley, working from the back to front side.

1075D210AA

3. Wind the shorter length of the cable counterclockwise

two turns, working from the front to the back side.

Then, slip the Cable Holding Jig onto the pulley.

Rear

4. Pass the Scanner Drive Cable into the pulley as

shown so that the round bead is at the center of the

pulley.

5. Holding the pulley as shown, wind the side of the

cable with two fixing beads clockwise six turns around

the pulley, working from the back to front side.

Front

1. Pass the Scanner Drive Cable into the pulley as

shown so that the round bead is at the center of the

pulley.

Make sure that no part of the cable rides on the other.

NOTE

1075D363AA

1075D364AA

D-39