Specifications

3. Wind the other length of the cable two and 1/2 turns

counterclockwise around the Cable Drive Gear,

working from the front to back side. Then, tape it.

4. Place the Cable Drive Gear onto the lower frame and

insert a wrench into the hole to position the gear.

5. Wind both lengths of the cable around the pulleys and

pull the spring to connect the two lengths.

6. Remove the wrench and peel off two pieces of tape.

7. Mount the Lens Drive Motor Assy by reversing the

order of disassembly. Do not, however, secure the

cam into position.

When winding the cable, make sure that no part of

the cable rides on the other.

NOTE

∗

When securing the cable to the Lens Base Plate, make

sure that dimension A shown measures 4 ±1 mm.

D-36