Specifications

4. Remove two screws shown and turn the Scanner sideways to remove the Scanner from the
copier.
1. Remove the Scanner.
2. Remove one screw and the Exposure Lamp terminal.
3. Remove the Exposure Lamp.
4. Using a soft cloth dampened with alcohol, clean the
lamp by gently wiping its surface in one direction.
(4) Cleaning of the Exposure Lamp
(5) Resetting of the Exposure Lamp Thermal Switch
When the Exposure Lamp has been cleaned or
replaced, be sure to make the "adjustment of
exposure level in the Auto Exposure mode." (See p.
D-90.)
NOTE
When reinstalling the lamp, point the protruding navel
of the lamp toward the opening in the Lamp Reflector
so that the protruding navel will not hit against the
Lamp Reflector.
NOTE
If the Exposure Lamp Thermal Switch is operated to
cut off the circuit, press the red reset button shown,
which resets the Exposure Lamp Thermal Switch.
Perform this step after unplugging the power cord.
NOTE
D-30