Specifications

2-4. OPTICAL SECTION
(1) Cleaning of the Original Glass
1075D040AA
1. Wipe clean the Original Glass with a soft cloth.
1. Remove the Original Glass.
2. Using a soft cloth, wipe clean the Scanner
Rails/Bushings (at the front).
3. Using a soft cloth, wipe clean the Scanner
Rails/Bushings (in the rear).
1. Remove the Original Glass.
2. Remove the Exposure Lamp flat cable holder.
3. Unplug one connector.
The surface of the Original Glass is coated with
conductive material. Do not use a wax-based
detergent.
An alcohol-dampened cloth may be used if the glass
is seriously contaminated.
NOTE
(2) Cleaning of the Scanner Rails/Bushings
(3) Removal of the Scanner
Apply lubricant to the Scanner Rails/Bushings after
they have been cleaned.
NOTE
D-29