Specifications

No. Part Name Removal Procedure
15 Rear Upper Cover Remove 3 Rear Upper Cover mounting screws.
16 Upper Rear Cover
Remove 4 AFR-9 mounting screws. → Remove 2
Ornament Covers. → Remove 2 Upper Rear Cover
mounting screws.
17 AFR-9
Unplug one connector. → Remove 2 AFR-9 mounting
screws.
18 Original Glass
19 Original Width Scale
20 Upper Left Cover
Remove the Upper Rear Cover. → Remove the Control
Panel. → Remove 2 Upper Left Cover mounting screws.
21 Left Upper Cover
Open the Front Upper Door. → Remove 4 Left Upper
Cover mounting screws.
23 Left Door
Remove the Left Rear Cover. → Open the Left Door and
pull it up.
24 Left Rear Cover Remove 3 Left Rear Cover mounting screws.
25 Rear Lower Cover Remove 4 Rear Lower Cover mounting screws.
◆ Removal of the Control Panel Unit (No. 3)
1. Remove the Right Upper Cover and Left Upper Cover.
2. Raise the AFR-9 and remove the magnet catches by removing two screws.
3. Loosen four screws on the right and left as illustrated below and remove one screw beside the
Toner Bottle.
4. Raising the Control Panel Unit, unplug three connectors. This allows the Control Panel Unit to be
removed.
*
To remove Control Panel UN1 only, loosen two screws (A) and, raising the Control Panel, unplug
two connectors.
Raise the AFR-9. ⇒ Remove 2 Original Width Scale
mounting screws.
Note: When the Original Width Scale has been
removed, use care not to lose two springs.
A
D-8