Specifications

(7) Manual Bypass Take-Up Control
•
Manual Feed Paper Pick-Up Solenoid SL9, which presses the Manual
Bypass Take-Up Roll against and releases it from the paper stack on the
Multi Bypass Table, is controlled by the SL9 ON signal output from pin 54
of IC5A and SL9 OFF signal output from pin 55 of IC5A on Master Board
PWB-A.
•
Manual Feed Paper Take-Up Clutch CL5, which couples the drive from
Transport Motor M3, is controlled by the CL5 Remote signal output from
pin 50 of IC5A on PWB-A.
•
Here is the timing chart.
1075C49MAA
Fusing Motor
(M6)
1075T120CA
500 msec.
SL9 OFF Signal
H
L
H
L
Manual Feed Paper
Pick-Up Solenoid (SL9)
ON
OFF
Manual Feed Paper
Take-Up Clutch (CL5)
ON
OFF
500 msec. 500 mse
500 msec.
5 msec.
60 msec.
5 msec.
100 msec.
60 msec.
90 msec.
50 msec.
90 msec.50 msec.
100 msec.
ON
OFF
ON
OFF
H
L
ON
OFF
H
L
SL9 ON Signal
Transport Motor
(M3)
Transport Roller
Sensor (PC26)
Synchronizing
Motor (M4)
Paper Leading Edge
Sensor (PC27)
Start Key ON
Retracted RetractedPressed
TRON for 1st Copy TRON for 2nd Copy
<Multi Copy Cycle for 2 Copies>
M-135