Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-10
•
This mode is used to make various settings according to the user’s needs.
<Setting Procedure>
1. Hold down the Panel Reset key for about 3 seconds to set the copier into the User
mode. (“U” appears on the Zoom Ratio Indicator.)
2. From the 10-Keys, enter the number assigned to the desired function. (The number
entered appears following the letter “U” on the Zoom Ratio Indicator.)
3. Press the Start key. (Then, the current setting for that particular function appears on the
Multi-Copy Display.)
4. Press the Clear key.
5. Make a new setting.
6. Press the Start key to validate the entry of the new setting.
Note
If the setting data entered is outside the specifications, it is not validated and is shown blink-
ing.
<Resetting Procedure>
•
Press the Panel Reset key to return to the Basic screen.
4 USER MODE
4-1. Functions Available from the User Mode
No. Function No. Function
✽
0
Mixed Original Detection
✽
18
Priority Orig. Copy type
✽✽
4
Lightweight Original 20 Auto clear ON/OFF
✽
6
Smaller Originals 21 Energy Saver ON Timing
7 Auto Power OFF Disabling
✽✽
23
Auto Clear for Plug-In
Counter
✽
9
File Margin
✽✽
24
Sort/Non-Sort Switching
ON/OFF
✽
10
Priority Paper Size/Source 28 Auto Power OFF Timing
✽✽
12
APS/AMS/Manual Priority
✽
51
Special Paper Setting
(1st Drawer)
13 Optimum Exposure Level
✽
52
Special Paper Setting
(2nd Drawer)
14
Priority Manual Exposure
Level
✽
53
Special Paper Setting
(3rd Drawer)
✽✽
15
Finishing Mode Priority
✽
54
Special Paper Setting
(4th Drawer)
✽
For 23 cpm Copier only
✽✽
For 18/23 cpm Copier only
4-2. User Mode Setting Procedure