Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
D-46
6. Unplug the solenoid connector.
7. Remove the harness from the Solenoid Unit
clamps at two places.
1139D209AA
8. Remove one screw and the Solenoid Unit.
1139D210AA
NOTE
If the solenoid has been removed from the Solenoid
Unit, make the adjustment shown on the left with the
Solenoid Unit installed in the Exit/Duplex Switching
Unit.
1139D211AA
Make the adjustment
with the Lever in contact
with the metal plate.
4 mm
9. Remove three screws and the Copy Tray Holder.
1139D212AA
10. Remove four screws and the Lower Guide.
1139D213AA