Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
D-32
Replacement of the Cleaning Blade
Applying Toner to Cleaning Blade
6. Tilt the Developing Unit to remove the developer.
1139D154AA
7. Remove two screws and the Lid.
1139D164AA
8. Remove the spring.
9. Remove two screws, one spring, one cap and the
Cleaning Blade. Replace it with a new one.
NOTE
When the Cleaning Blade has been replaced, apply
toner to the entire surface of the new Cleaning Blade.
1139D165AA
Apply toner to the entire surface of the Cleaning Blade.
(Do not forget to coat the surfaces on both ends.)
Install the PC Drum.
Apply a thin coat of toner to the PC Drum.
Turn the PC Drum 1/2 turns backward, then turn it one complete turn forward.