Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT

98.04.13

D-26

3. Fit the belt in position and secure Scanner Motor

M4 (three screws).

1149D040AA

1149D041AB

4. Hook the length of cable on the left (looking at the

copier from the rear), around Pulleys C and B and

secure it to the frame.

1149D042AA

5. Peeling off the tape, pull the length of cable on the

right (looking at the copier from the rear) and hook

it onto Pulleys A and B.

1149D043AA

NOTE

•

Hook the length of cable on the left (looking at the

copier from the rear) onto the lower groove in Pully

B. (Fit the round terminal as illustrated on the left.)

•

Hook the length of cable on the right (looking at the

copier from the rear) onto the upper groove in Pulley

6. Fit the cable into the groove in the cable guide and

hook the spring.

7. Mount PWB-A (four screws).

1139D142AA