Service manual
FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 TROUBLESHOOTING
98.05.15
T- 1 9
Paper Feed Cabinet Take-Up Misfeed Clearing Procedure
Symptom
Step
Check Item
Result
Action
•
Paper is not
taken up at all.
•
Paper is station-
ary before the
Paper Take-Up
Sensor.
1
Does the paper being used
meet product specifica-
tions?
NO
Instruct the user to use the
paper that meets product
specifications.
2
Is the paper curled, waved,
or damp? YES
Change the paper.
Instruct the user in how to
store the paper.
3
Is the Paper Take-Up Motor
turning when the Start Key
is pressed?
NO
Check for possible overload.
Replace PWB-A or PF-206
PWB-A.
Check the Motor.
4
Is the Paper Take-Up Roll
or Separator Roll deformed,
worn, or dirty with paper
dust?
YES
Clean or replace the Paper
Take-Up or Separator Roll.
•
Paper is
stationary
before the
Vertical Trans-
port Rollers.
5
Check 3rd/4th Drawer
Paper Take-Up Sensor
(PC21/PC29). See p. T-2.
PC21: (PF-206) PWB-A
IC1A PE3.
PC29: (PF-206) PWB-A
IC2A PB3.
YES
Replace PWB-A or PF-206
PWB-A.
NO
Check the Actuator for
operation.
Check the Paper Take-Up
Sensor.
6
Is Vertical Transport Motor
M21 turning when the Start
Key is pressed?
NO
Check for possible overload.
Replace PWB-A or PF-206
PWB-A.
Check the Motor.
7
Is the Vertical Transport
Roller or Guide Plate
deformed, worn, or dirty
with paper dust?
YES
Clean or replace the
Vertical Transport Roller or
Guide Plate.
•
Paper is
stationary near
Vertical Trans-
port Sensor 4
PC22.
8
Check Vertical Transport
Sensor 4 PC22.
See p. T-2 (PF-206) PWB-A
IC1A PC2.
YES
Replace PWB-A or PF-206
PWB-A.
NO
Check the Actuator for
operation and check the
Sensor.
•
Paper is
stationary
before the
copier.
9
Check Vertical Transport
Sensor 4 PC22.
See p. T-2 (PF-206) PWB-A
IC1A PC2.
YES
Replace PWB-A or PF-206
PWB-A.
NO
Check the Actuator for
operation and check the
Sensor.
10
Is the Vertical Transport
Roller or Guide Plate
deformed, worn, or dirty
with paper dust?
YES
Clean or replace the Verti-
cal Transport Roller or
Guide Plate.
NO
Check the Paper Feed Cab-
inet for positive connection
to the copier.