Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-30
•
This function allows the Tech. Rep. to enter the size of the paper loaded in each drawer
(except the 1st Drawer which is a Universal Tray).
<Setting Procedure>
1. Select the Paper Size Input function.
2. Each press of the Paper Select key shows a new paper size in the following order.
NOTE
For PF-112, use 3F and 3C for the size input.
3. Show the paper size to be set and press the Clear key to clear the current size.
4. From the 10-Keys, enter the new paper size.
•
This function is used to check the time it takes the copier to complete different functions
and to make a control panel display test and sensor check.
<Setting Procedure>
1. Select the Display function.
2. From the 10-Keys, enter the number (0, 1, 2, 6, or 7) corresponding to the item to be
checked/set.
[Service Mode Display]
(9) Paper Size Input (For 23 cpm Copier Only)
Order Zoom Ratio Indicator Multi-Copy Display Description
1
Current paper size
2F 2nd Drawer length
2 2C 2nd Drawer width
33F
3rd Drawer (Paper Feed Cabinet)
length
43C
3rd Drawer (Paper Feed Cabinet)
width
54F
4th Drawer (Paper Feed Cabinet)
length
64C
4th Drawer (Paper Feed Cabinet)
width
7 5F (Japan Only)
8 5C (Japan Only)
(10) Display
Display Function Setting
d0
<Warm-up time>
The warm-up time is shown on the Zoom Ratio Indicator
d1
<First copy time>
The first copy time is shown on the Zoom Ratio Indicator
d2
<Multiple copy time>
The multiple copy time is shown on the Zoom Ratio Indicator
d6
<Display test>
All LEDs on the control panel are turned ON and OFF (blinking) for
checking operations.
d7
<Sensor check>
When a misfeed or malfunction occurs, this function is used to make a
sensor check to isolate the possible faulty spot.)
NOTE
For details, see TROUBLESHOOTING.