Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-23
[Service Mode Tech. Rep. Choice]
Choice No.
Setting (The default is .)
C-20 <Leading Edge Erase>
Varies the width of erase on the leading edge.
NOTE
When the setting is changed, it results in the erase width being
changed by about 3 mm.
C-21 <Trailing Edge Erase>
Varies the width of erase on the trailing edge.
NOTE
When the setting is changed, it results in the erase width being
changed by about 3 mm.
C-23 <Loop Length Adjustment>
Adjust the length of the loop to be formed in paper before the Syn-
chronizing Rollers.
C-31 to 34
✽
For 23 cpm
Copier only
✽✽
For 18/23 cpm
Copier only
<Original Stop Position Adjustment>
Adjust the position at which to stop the original in each of the following
ADF modes.
✽✽
C-31: 1-sided original stop position adjustment
✽
C-32: 2-sided original stop position adjustment
✽
C-33: 2-in-1 original stop position adjustment
✽
C-34: 2-in-1 original distance adjustment
✽✽
C-37: S-ADF mode original stop position adjustment
✽✽
C-38: ADF Registration Loop adjustment
NOTE
The stop position is farther away from the Original Width Scale (or a
greater distance between 2-in-1 originals) in the + direction.
Highlighted
Data 0
Description Smaller width Greater width
1
Data 0
Description Smaller width Greater width
1
Data Description Data Description
47
48
49
Loop length about 4.9 mm
Loop length about 5.6 mm
Loop length about 6.3 mm
Loop length about 7.0 mm
51
52
53
Loop length about 7.7 mm
Loop length about 8.4 mm
Loop length about 9.1 mm
50
Data
43.................................... ................................. 58
Adjustment
Value
−
7 mm
.............................±
0 mm........................+8 mm
50