Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-22
[Service Mode Tech. Rep. Choice]
Choice No.
Setting (The default is .)
C-5 <PM Counter>
Select either PM Counter or Copy Kit Counter.
NOTE
If this function is set to “2,” the copier gives an indication to replace
the IU and inhibits the initiation of a new copy cycle even if C-4 is set
to “0.”
C-6
✽✽
For 18/23 cpm
Copier only
<Plug-In Counter Copying Enable/Disable>
Select whether to enable or disable copying according to whether the
Plug-In Counter is plugged in or not.
NOTE
Be sure to set this function to “1” when the Plug-In Counter is
installed.
C-7 <IU 60K Stop>
Select whether or not to inhibit copying when IU Counter has counted
60K.
Default: 0 (inch areas) / 1 (metric areas)
C-15 <Toner Empty Stop>
Select whether or not to inhibit copying when a toner-empty condition
is detected.
NOTE
If “1” is set, the copier inhibits copying when it detects a T/C of 3.5%
or lower.
Highlighted
Data Description
PM Counter
1
Copy Kit Counter: Copying not inhibited after the
counter has counted down to zero.
2
Copy Kit Counter: Copying inhibited after the counter
has counted down to zero.
0
Data 1
Description
Permits copying even
when the Plug-In Counter
is not plugged in.
Inhibits copying when the
Plug-In Counter is not
plugged in.
0
Data 0 1
Description Permits copying. Inhibits copying.
Data 1
Description Permits copying. Inhibits copying.
0