Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-20
•
This function allows the Tech. Rep. to make various settings and adjustments.
<Setting Procedure>
1. Press “2” from the 10-Keys. (The Zoom Ratio Indicator shows “C.”)
2. Press the number assigned to the desired Tech. Rep. Choice. (The Zoom Ratio Indica-
tor shows “C” plus the number of the chosen function.)
3. Press the Start key. (The Multi-Copy Display shows the current setting for the chosen
function.)
4. Clear the current setting using the Clear key and enter the new setting from the 10-Key
Pad.
5. Press the Start key to validate the new setting.
NOTE
If the setting is illegal, it is not validated and is shown blinking.
<Test Copy>
•
A test copy can be made by entering “C” of the Tech. Rep. Choice No., holding down the
Stop key and pressing the Start key.
<Leaving the Function>
•
Press the Panel Reset key twice to go back to the Basic screen.
[Service Mode Tech. Rep. Choice]
(2) Tech. Rep. Choice
Choice No.
Setting (The default is .)
C-0
✽
For 23 cpm
Copier only
<Plug-In Counter Counting>
Select the condition by which the Plug-In Counter count is increased.
NOTE
See the Count-up Table for details.
C-1 <Size Counter Counting>
Select the size of the paper to be counted by the Size Counter.
NOTE
See the Count-up Table for details.
Highlighted
Data 1
Description
Counts the number of
sheets of paper fed out.
Counts the number of
copy processes carried
out.
0
Data 0 2 3
Description
(Metric
areas)
No count A3 A3/B4 A3/B4/FLS
Description
(Inch areas)
No count 11” × 17”
11” × 17”,
8-1/2” × 14”
11” × 17”,
8-1/2” × 14”,
11” × 14”
1