Service manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-18
•
This function allows the Tech. Rep. to perform various functional tests and adjustments.
<Setting Procedure>
1. Enter the number assigned to the desired test from the 10-Keys. (The number appears
on the Multi-Copy Display.)
2. Press the Start key to start the test.
3. Press the Stop key to stop the test.
<Test Copy>
•
A test copy can be made by entering “F3, F5” of the Test No., holding down the Stop key
and pressing the Start key.
<Leaving the Function>
•
Press the Panel Reset key twice to go back to the Basic screen.
[Service Mode Test]
5-3. Settings in the Service Mode
(1) Test
Test No. Description
F1 <Paper Passage Test>
A paper passage test is carried out to check for correct sensor opera-
tion without having to wait for the copier to complete warming up. It
provides the following two modes:
1. Normal mode (The Zoom Ratio Indicator shows “On.”)
2. Load OFF mode, in which some parts are put in an inactive state
(The Zoom Ratio Indicator shows “Off.”)
<Procedure>
1. Using the Zoom Up/Down key, select either one of the two modes.
2. Press the Start key.
<To quit>
•
Press the Stop key, or the test stops when paper runs out.
F2 <PC Drum Charge/Image Transfer Coronas Output>
Do not use this test as it is only for factory adjustment.
F3 <Exposure Lamp Voltage Adjustment>
This test allows the Tech. Rep. to adjust the maximum Exposure
Lamp voltage and the optimum exposure setting in the Manual Expo-
sure mode. (It runs for 30 sec.)
NOTE
For details, see DIS/REASSEMBLY, ADJUSTMENT.
F4 <Paper Separator Corona Output>
Do not use this test as it is only for factory adjustment.
F5 <AE Sensor Automatic Adjustment>
This test automatically adjusts the AE Sensor. (It runs for 5 sec.)
NOTE
For details, see DIS/REASSEMBLY, ADJUSTMENT.