Operation Manual
PROGRAM MODE FLASH OPERATION
The camera uses an advanced flash control system to provide correct flash
exposures in P mode whenever it is required. The camera's TTL
(through-the-lens) flash metering system controls the flash output to
ensure a proper exposure.
Viewfinder Signals and Flash Control
As soon as the camera detects that flash will be required, the flash-on
indicatorappears in the viewfinder data panel. The flash-ready
indicator will light when the flash is fully charged. When you press
the shutter release partway down, the flash will pop-up, and it will fire
when you take the picture. After you release the shutter, if the flash output
was sufficient to provide a correct exposure, the flash-ready signal will
blink. The flash can also be forced to fire at any time by pressing and
holding the flash pop-up button while you take the picture.
• The shutter will lock while the built-in flash is charging to prevent
underexposure.
• If the flash pops up and you press it back down, it will remain off until
you take the camera away from your eye and wait for Eye-Start to turn off
the metering system (aperture and shutter speed will disappear from the
body data panel). To resume normal autoflash operation without taking
the camera away from your eye, press the flash pop-up button.
• If you press the flash pop-up button and do not keep it pressed down,
the flash will pop-up, but will only fire when necessary.
• The built-in flash or an accessory flash will not fire while the camera is
set in Creative Program Control (PA/PS).
64