Service manual
Table Of Contents
- 1.pdf
- 3-4.pdf
- 5.pdf
- REPAIR GUIDE
- Precautions
- 1. Disassembly of the exterior parts
- ■Wires arrangement
- 2. Disassembly of the I/O FPC ASSY, MAIN PCB ASSY
- 3. Disassembly of the SUB PLATE L, BATTERY CHAMBER
- 4. Disassembly of the CCD ASSY, SHUTTER ASSY
- ■CCD inclination adjustment / repair
- 5. Disassembly-1 of the MIRROR BOX ASSY
- 6. Disassembly-2 of the MIRROR BOX ASSY
- 7. Disassembly-3 of the MIRROR BOX ASSY
- 8. Disassembly of the BATTERY CHAMBER, LCD 101
- 9. Disassembly of the TOP COVER ASSY
- 10. Disassembly of the FRONT COVER ASSY, BACK COVER ASSY
- ■Required adjustment, setting and confirmation items after repairing(exchanging parts)
- ■Related adjustment and required setting items
- ■Viewfinder Back Adjustment
- ■Preparing the 2186 adjustment program
- ■Starting up the 2186 adjustment program (in the adjustment mode)
- ■Adjustment of the PI-PR
- ■Adjustment of the frequency for camera shaking (FREQUENCY)
- ■Adjustment of the servo for camera shaking (SERVO)
- ■Adjustment of the gyro for camera shaking (GYRO)
- ■Adjustment of CCD Vsub voltage (VSUB)
- ■Setting for the adjustment of CCD AORI & CENTER
- ■Adjustment / Checking of CCD AORI & CENTER
- ■Manual Set SS & X-Sync. Time-lag Check
- ■Adjustment Manual Set SS
- ■Preparation before AF adjustment
- ■AF Area Adjustment
- ■Pitch Yaw Adjustment
- ■FLATNESS Adjustment
- ■EZ Check / Adjustment
- ■EZ Adjustment
- ■EZ Check
- ■EZ SHIFT
- ■Aperture Preset Check / Adjustment
- ■Check / Adjustment of the AE (AE)
- ■Sensitivity adjustment (CCD GAIN)
- ■Adjustment of the defective pixel (DEFECT PIXEL)
- ■Adjustment of white balance (WB)
- ■Adjustment of the camera shaking compensation (SHAKE GAIN)
- ■FLASH LEVEL SHIFT
- ■Setting of Destination (DESTINATION)
- ■CAMERA LOG
- ■LCD All Segment On
- ■Light Source-A Maintenance
- ■Error code on adjustment program
- ■Measuring instrument
- ■Subsidiary Materials
- REPAIR GUIDE
- 6.pdf
- TROUBLESHOOTING CHART
- 7.pdf
- 8.pdf
- 9.pdf
5
CHECK LIST
(2186)
Check
1. Insert the CF card in the cart slot of the camera, and set the camera on the
tripod.
2. Set up the equipment and distance as shown on the following table.
3. Capture the charts (for Wide-angle) at the when focusing from both ∞ and near
end for 5 times.
* Light up the chart (center and 4 corners) with the fluorescent stand SQ967W
(inverter fluorescent light)). The dim lighting may result in the incorrect
reading due to low contrast.
If the amount of the light is insufficient, capture each half separately.
4. Open the images with Adobe Photoshop on PC, check the resolving power.
* Do not apply any image correction to test images on Photoshop. (Image
correction such as contrast, tone Curves compensation or histogram operation
may cause incorrect reading.)
* All the 10 pictures taken should have resolving power as below when read
under magnification of 2.5X.
Standard Center: 884 lines or greater
Moreover, satisfy the following about the scene of resolving power best among
ten scenes.
Standard Center: 1400 lines or greater/ Corners: 775 lines or greater
Reading
Number of lines
(television resolution)
Reading
Number of lines
(television resolution)
A 1400 G 800
B 1300 H 700
C 1200 I 600
D 1100 J 500
E 1000 K 400
F 900
Ima
g
e size 3008x2000 (L) or 2256x1496 (M)
Com
p
ression Mode Fine or Std.
Ex
p
osure Mode A mode (A
p
erture full o
p
en)
Focus Mode Auto Focus
Flash Mode Cancell
Distance A
pp
rox. 3m (Usin
g
Standard lens 2613)