Instruction manual

With the camera on a tripod, position the subject within the
focus frame.
Point the remote control’s emitter window toward the
camera’s self-timer lamp/remote-control receiver.
Pressing the information display button changes the display
format, see page 43.
Digital zoom (p. 102) is activated by the digital-zoom
buttons.
79
Emitter window
Release button
Digital-zoom buttons
Controller
Information
display button
Battery chamber
Using the remote control
Press the release button or the center (2s) button of the controller to take the picture. The central
button delays the release of the shutter for approximately two seconds; the self-timer lamp and the
audio signal indicates the countdown. The self-timer lamp glows steadily just before the shutter
releases. The release button fires the shutter without a delay. If the flash is used, the shutter is released
after the flash has charged.
The focus and exposure are set when the release button or the central button of the controller is
pressed.
When recording movies or bulb exposures, pressing the release button or the central button of the
controller once starts the exposure; pressing the button a second time ends it.