Instruction manual

141
Auto Power Save
The camera will turn off the monitors to conserve battery power if no operation is made within a
certain period. The length of this period can be changed to 1, 3, 5, or 10 minutes. To restore power,
press the shutter-release button partway down or press the main switch. When the camera is
connected to the computer, the auto-power-save period is set to ten minutes. This period cannot be
changed. Auto power save is set in section 3 of the setup menu (p. 130).
If an operation is not made within thirty minutes, the camera will shut down. Press the main switch to
restore power.
Shutter FX
Volume
The volume of the audio signals and sound effects can be increased
or decreased in section 3 of the setup menu (p. 130). If the volume
is turned off, the audio signals, focus signal, and shutter FX are
disabled.
A shutter sound effect gives positive audio confirmation
when the shutter is released. The sound effects can be
turned off in section 3 of the setup menu (p. 130). Two shutter
effects are available. Signal 1 uses the shutter sound from
the Dynax/Maxxum 9 SLR. Signal 2 uses a mechanical
shutter sound taken from the legendary Minolta CLE.
Reset default –
Audio signals 1
Focus signal 1
Shutter FX 1
Volume 2
Power save 3 min.