Instruction manual

For the camera to be connected directly to
the computer and used as a remote
imaging device, the computer must be
equipped with a USB port as a standard
interface. The computer and the operating
system must be guaranteed by their
manufacturers to support USB interface.
See chart for system requirements.
The remote-camera driver software must
be installed. Specific application software,
such as Microsoft Net Meeting, is required
to view the images. This function cannot
be used with Macintosh computers.
9998
REMOTE CAMERA SYSTEM REQUIREMENTS
Minimum system requirements
Windows 98 Second Edition, Me,
2000 Professional, and XP.
Pentium II 300MHz or later
128MB of RAM. 256MB with Windows XP.
200MB of hard-disk space
800 X 600 16-bit color monitor
Remote camera tested with Microsoft Net
Meeting and Windows Messenger.
INSTALLING THE REMOTE CAMERA DRIVER
The driver needs only to be installed once. This
driver is not compatible with Macintosh operating
systems.
Before connecting the camera to the computer,
place the DiMAGE Viewer CD-ROM in the CD-
ROM drive. The DiMAGE installer menu should
automatically activate. To install the driver, click on
the DiMAGE remote-camera installer button.
The InstallSheild Wizard window is displayed. Click
the next button to continue.
The license agreement is displayed. if you accept
the agreement, click the yes button to continue.
Read the entire agreement carefully before
continuing. If you do not agree to the terms, click
the no button to exit the installation program.
An installation confirmation screen appears. To
install the remote camera driver, click “Yes.’ The no
button will cancel the operation without installing
the driver.
When the driver installation has been completed, a
message will be displayed. Click the finish button to
complete the operation.
DATA-TRANSFER MODE